[nsd-users] how to config one nsd zone as both master & slave using two interfaces -- one IPv4 & one IPv6?

[pgngw+dev001+nsd-users at f-m.fm]

On Sat, 04 Dec 2010 13:14 -0500, "Dave Knight" <dave at knig.ht> wrote:
> It's used in the case where a system has multiple interfaces/addresses
> from which packets might be sourced and you want NSD to use a specific
> one. This is useful for example when a nameserver allows transfers only
> to a specific address, you need to ensure that you are in fact requesting
> the transfer from that specific address.

well, this in-the-middle 'nsd' box is actually a VPS-hosted VM slice,
with 4 public, static IPs, (eth0, eth0:1, eth0:2, eth0:3), each in a
completely different subnet.

but, nsd is config'd to listen on only one of those IP interfaces
(eth0), with its two "ip-address:"-specs, on IPv4 & one IPv6.

so, iiuc, i'm still "ok" doing it the way you suggested.

thanks again!